Convert Your Old Euro Muzzle to Accept Bulk Rubber



tool kit

In your MAKO Spearguns Attack Pack Tool Kit you will need:

  • B) Food Grade Silicone
  • C) Measuring tape
  • D) Pliers
  • F) Scissors
  • H) Lighter

You will also need:

NOTE: Bridle wishbones are to be used only with shafts with "Sharkfin Tabs", Pinned Tabs" or shafts with "rounded notches". "Unrounded notched shafts" will cut through bridle wishbones.

WARNING: Some speros will file their notches to accept bridle wishbones, however this process weakens an already weaker shaft and increases the chance of a broken shaft.

MAKO Spearguns offers only high quality shafts with "Pinned Tabs" or "Sharkfin Tabs" that are almost 50% stronger than notched spears.

The bridge on the MAKO closed muzzle has been raised to accept these pin tabbed shafts. Do Not use these spears with conventional closed muzzles.

tab 1

Sharkfin Tabbed Shafts

tab 1

Smooth Notch Shafts

tab 1

Sharp Notch Shafts


Our stainless steel euro muzzle adapters allow you to convert your old euro gun to accept bulk rubber and bridle wishbones so you don't have to use euro latex and metal wishbones ever again.

euro muzzle adapterseuro muzzle adapters installed

STEP 1
Measure and cut 2 bands to length. Spray euro muzzle adapter ball with silicone and using a pair of pliers, insert ball into tubing.

muzzle adapterssprayinsertcomplete

STEP 2
Use band tying line to tie a constrictor knot to secure the muzzle adapters into tubing. Line up constrictor knot and use pliers to tighten knot. YOU MUST PULL HARD! Then turn tubing over and tie a 2nd constrictor knot on the back side of the tubing.

knot 1knot 2knot 3knot 4pull

STEP 3
After tying the second constrictor knot on the opposite side of where the first constrictor knot was tied, remove excess material and burn ends to prevent fraying.

cutburncomplete

STEP 4
Screw euro muzzle adapters into muzzle and check to make sure the bands are of equal length. Trim if necessary.

screw intighten

STEP 5
At his point, there are 3 options as listed below. For safety reasons, we recommend option #1.


Option #1
Purchase a "pinned Tabbed Shaft" or Sharkfin Tabbed Shaft" and use a corded style wishbone instead of the French wishbone. DO NOT try to use corded wishbones with un rounded notched Euro shafts.

pinned tabshark finwishbone insertswishbonebeaded wishbone


Option #2
If you are dead set on staying with your non rounded euro notched shaft and want to stay with a French wishbone, you can install our "Articulated Wishbones for Bulk Rubber".

french wishbonefrench wishboneinstalltie knotdone

Option #3
If you are still dead set on staying with your non rounded euro notched shaft and want to stay with a French wishbone, you can install 2 additional pieces of our Euro Muzzle Adapters" on the wishbone end of your rubbers and then install a "Screw on French Articulated Wishbone".

french wishbonefrench wishbonetie knotscew ondone